Hi all, I just received a Quest M3 with thermocouples installed already. I
have three at the moment. ET, MET, and another probe that is the exhaust
temp coming off the beans. I plan on adding a dedicated BT as well.
I am running this sketch
following these instructions
are found within the same folder as the sketch.
Serial Exception:Unable to open serial port is the error I'm getting within
Artisan but I can't even select the proper Comm Port. All I have is Generic
CDC. Arduino software is recognizing it because I need that port to load
the sketches on the Arduino in the first place. Arduino recognizes it as:
/dev/cu.usbmodem14301 I'm running the newest version of Mojave for my OS.
If I manually type in that in Artisan I still won't get anything.
Also, within the Serial Monitor using the code (chan,1234) won't cause
anything to show either.
The "but" of all of this is the fact that to my LCD screen connected to the
TC4, within the sketch it is programmed to display time, RoR, and the first
two channels ET, and BT. These numbers are showing up and are responding to
I have a USB-C dongle that breaks off to three USB 3.0's. I also tried it
with a singular USB-C to USB3.0 dongle on different ports. Arduino will
find it but Artisan won't.
Does anyone know how to program on the LCD to show the third probe as well
and make it "MET" for example. I found the code on the sketch and tried
else command: lcd.setCursor( 09, 2 );
lcd.print( F("MET:") );
but it didn't seem to do anything.
Thanks in advance for whoever knows these things.
Show replies by date