I am using Artisan 0.9.9.x with a Fuji PID that does not have the optional
RS485 interface. Model PXG4PYY1-0VY00 (voltage control output 1-5V to an
Autonics heater controller).
Fuji provide a serial (RS232) communications port, possibly on the PXG
models. This is presented as a 2.5mm stereo TRS jack and offer an optional
I made my own RS232 lead- 2.5mm sub-mini stereo plug to 9 pin RS232 female;
tip=>pin2, ring=>pin3, sleeve=>pin 5. Works perfectly with Fuji parameter
Artisan is connecting and controlling the PID, ramp soak is working well
The first minor issue I have found is that at 0% output Artisan shows PID %
as 100% (otherwise working correctly)
Secondly, the serial port settings (Device Assignment/Serial Ports Config
ET/BT tab) always reverts to 'odd' parity, when the required parity setting
for this connection is 'none' (unlike RS485, there is no option in the PID
to change RS232 serial port settings).
Show replies by date