Op 14 mei 2016, om 11:27 heeft Brad Bradshaw
<ianabradshaw(a)gmail.com> het volgende geschreven:
I made my own RS232 lead- 2.5mm sub-mini stereo plug to 9 pin RS232 female; tip=>pin2,
ring=>pin3, sleeve=>pin 5. Works perfectly with Fuji parameter loader software.
Very clever! I bought mine and the first did not work but the second was very good.
The first minor issue I have found is that at 0% output Artisan shows PID % as 100%
(otherwise working correctly)
I have that only when it is all switched on but inactive. As soon as the system is active,
the numbers are correct. So it’s no issue really.
Secondly, the serial port settings (Device Assignment/Serial Ports Config ET/BT tab)
always reverts to 'odd' parity, when the required parity setting for this
connection is 'none' (unlike RS485, there is no option in the PID to change RS232
serial port settings).
I don’t have that issue in my setup. Once I have it set, it works. Here I get that menu in
Config -> Serial -> Modbus so we might have different versions.