I can`t connect our roaster Coffee-Tech Ghibli R15 to Artisan, I tried
many sets usually using MODBUS, but whit 0 effect. (also following
manual from same roaster-producer
PC is connected whit USB to RS485 Module
the Module is connected whit CH 102 series controller (there is 3 pins
for RS485). I'm using Win7 and the device is connected whit no problems
(device manager - Ports - USB Serial Port(COM3), - USB controllers- USB
In this Artisan version (0.9.8(7)) is Error readSingleRegister()
Exception responce@line 25219
Can anyone help me connect this roaster to Artisan, I'm real
I'm having an issue with only one type of probe, the alt BT probe, and I'm
not sure why. Eric S. was kind enough to send me a replacement, but I get
the same results with the replacement. The reading of the alt BT probe
gradually gets further and further apart from the standard BT probe as the
temp gets higher. So at 100 degrees, the alt bt and bt read the same. At
200, they start to drift by about 25 degrees, by 300, 75 degrees (Those are
rough numbers..). I'm not sure why its doing this, but I'd really like to
get the alt bt probe working so I can do smaller batches.
Things I've tried:
1. I plugged both probes into my Thermoworks Blutherm duo and the probes
read exactly the same at all temperatures.
2. I used the serial monitor to get readings, and they were similar to
those in the artisan software.
3. Right now I use k-type female sockets, so I tried hard wiring and
received the same results.
4. Tried different ports, same results.
Would anyone have any ideas as to why this is happening or what else I can
do to troubleshoot?