I've recently had a lot of crashes with Artisan while it's recording the roast; usually 10-11 minutes in to the roast. I can't find any rhyme or reason to it, but I attached the crash report from my Mac.
--
Kyle Iseminger
Flying Baron Roasters :: (720) 384-7811
Not sure if I am doing this right but here goes: I am trying to use a myPClab with Artisan on a Mac 10.6.8 by using the USB cable that came with it and adjusting all the settings in Artisan. When I go to use Artisan it does not see any of the probes including the built in probe. Thanks - Blair
Hi all!
Thanks for developing Artisan! It's an amazing piece of software.
I am trying to configure a Watlow PM6 controller for Artisan Beta 4. I have limited PLC and controls knowledge, so please bear with me.
I have installed the requisite drivers for my 485 to usb converter. I am using RTD probes and can read the temperatures in the specified registers through modbus (Watlow modbus test program). I can configure and get Artisan to request the data from the Watlow registers and the Watlow communicates during each call for sample (at the correct intervals). Also, the Watlow is in Modbus mode, using the correct data map (map 2) and sends the data in lo-hi. Slaves are set to 1, reading from regsiters 360 and 450, baud rate set to 19200 and using the correct COM port (COM4 on my system).
I cannot get Artisan to display the temperatures read by the RTDs. It either displays nothing for both or seemingly random numbers which do not correlate. I'm not sure if there is an issue with my settings or if the Beta 4 has an issue with this specific controller?
Any help would be fantastic and much appreciated.
Best regards,Matt