Dear reader,
I have almost finished the overhaul of my Probat LG-3 and am now in the final stages.
I have 2 PXR 4 Fuji controllers (not hooked up yet with 2 PT-100 probes, one for bean temperature and one for exhaust temperature or ?),
How do I use them together with Artisan software?
Cheers,
Piet
The specific type is:
TYPE: PXR 4 NEA11NM00
Front size 48mm x 48mm, dual display, 3 keys
INPUT SIGNAL
RTD, PT100 ohm, 3 wire type (°C)
CONTROL OUTPUT 1 (Direct/Reverse action selectable)
4 - 20 mA DC output - Note 2 & 4
CONTROL OUTPUT 2 (Direct/Reverse action selectable)
Relay contact output - Note 3 & 5
ADDITIONAL FUNCTIONS 1
1 point alarm (1 relay output)
POWER SUPPLY
Standard (100 - 240 VAC) - without instruction manual
ADDITIONAL FUNCTIONS 2
RS485 - MODBUS communication
NOTES :
2- Factory (default) setting is "Reverse Action Mode".
3- Factory (default) setting is "Direct Action Mode".
4- Not available with heater burnout alarm. (9th digit code "2", "3", "6", "7"and "H" can not be selected.)
5- Not available with 9th code "3", "7", "F", "G", "H", "M" or "P".